InnoDisk mSATA SSD supports SATA II standard (3.0Gb/s) with good performance and thus performs faster data transfer rate. Sustain read can reach up to 100MB per second (max), and sustain write reach up to 60MB per second (max). Moreover, InnoDisk mSATA SSD is designed as the standard Mini PCIe form factor, and compatible with Mini PCIe slot

The SATA II bridge controller is 3.0Gbps, and supports hot-plug. This SATA II controller support four flash IC and communicates with host interface, this SATA II controller can support the flash ICs for 4kbyte per page. InnoDisk mSATA SSD is suitable in industrial field, it effectively reduces the booting time of operation system and the power consumption is less than hard disk drive (HDD). It can work under harsh environment, complies with ATA protocol, no additional drives are required, and can be configured as a boot device or data storage device.

Interface: Serial ATA II 3.0Gbps Capacity: 2GB~16GB Form factor: Standard Mini PCIe Data transfer rate: Read- 100MB/sec., Write- 60MB/sec. Burst Transfer Rate: 300MB/sec. Power Requirement: 3.3V DC single power supply Access time: 0.3ms Error Correction Function: Built-in ECC corrects up to 8-bit per 512-Byte Dimension: 30x50.95x3.4mm

No additional device drivers are required. The InnoDisk mSATA SSD can be configured as a boot device.

A Serial ATA device may be either directly connected to a host or connected to a host through a cable. For connection via cable, the cable should be no longer than 1meter. The SATA interface has a separate connector for the power supply. Please contact us if you need a model with a Built-in Power from the Sata connection.

Flash memory can be erased within a limited number of times. This number is called the erase cycle limit or write endurance limit and is defined by the flash array vendor. The erase cycle limit applies to each individual erase block in the flash device. InnoDisk mSATA SSD uses a static wear-leveling algorithm to ensure that consecutive writes of a specific sector are not written physically to the same page and block in the flash. This spreads flash media usage evenly across all pages, thereby extending flash lifetime.

Operating Temperature Range Standard Grade: 00C to +700C Storage Temperature Range Standard Grade: --550C to +950C

Reliability Test Conditions Vibration: 7 to 2000 Hz, 20G, 3 axes Mechanical Shock Duration: Duration: 10ms, 50G, 3 axes Product Condition MTBF (Hours): InnoDisk mSATA SSD Telcordia SR-332 GB, 250C > 3,000,000

InnoDisk mSATA SSD supports the following transfer mode: PIO Mode: 0~4 Multiword DMA: 0~2 Ultra DMA: 0~6 InnoDisk mSATA power consumption Parameter mA Sustained Read 200 Sustained Write 190 IDLE 110 Note: Measured with 8GB device