Industrial Storage // memorydepot.com

2GB SATADOM D150SV Built-in Power on pin 7 [Version 2] DES9-02GJ30AW2SBF

SATA Disk on Module
2GB

Vertical Model - Based on High reliability Industrial SLC Chip
Wide Temp Built-in Power (pin7) Wide Temp

This DOM model has the built-in power input directly on the SATA port. It means you don't need to connect the SATA DOM to an external power source ( on the motherboard or power supply ). However please verify if your motherboard has the power capacity on SATA port ( on pin7 ) otherwise this unit will not work and on this case, we suggest the same model without the Built-in Power function.

Features:
  • Zero Mechanical Interference
  • High Reliability
  • Anti-Vibration Connector Design
  • Build-in Power Pin Design
  • Intelligent Wear Leveling
  • Auto ECC Function

    Please check all the various models on the page below.

    What is the difference between "regular" version and [Version2]?
    The [Version2] with part# ending with a "B" is simply a new revision of the model with an updated memory chip and firmware update, they have the exact same functionality and specifications. The [version 2] will be available in a longer time range and the "regular" version will phase out sooner. For a new project, we suggest to go with [Version2]

    • Mechanical Specification
    Interface SATA 3.0G
    Dimension(WxLxH) 20.8mm x 32.8mm x 8.0mm

    Wear Leveling
    Flash memory can be erased a limited number of times. This number is called the erase cycle limit or write endurance limit and is defined by the flash array vendor. The erase cycle limit applies to each individual erase block in the flash device SATADOM D150SV wide temp uses a wear-leveling algorithm to ensure that consecutive writes of a specific sector are not written physically to the same page in the flash. This spreads flash media usage evenly across all pages, thereby maximizing flash lifetime.

    Environmental Specifications
    Operating Temperature Standard Grade: 00C to +700C
    Industrial Grade: -400C to +850C
    Storage Temperature -550C to +950C
    Shock(Operating) 1500G
    Vibration(Operarting) 20G
    Humidity 5-95%,non-condensing
    Conformal Coating Optional
    Write Protect Support

    Reliabily and Durability

     Reliability

     Test Conditions
    Vibration 7 Hz to 2KHz,  20G
    Mechanical Shock Duration: 0.5ms, 1500G, 3 Axes
     
    Product Condition MTBF(Hours)
    SATADOM D150SV TELECORDIA SR-332 GB, 250C >4,000,000

    Transfer mode and Power consumption
    Power Consumption Mode Power Consumption(mA)
    Read 190
    Write 230
    Idle 165

    Electrical Specification
    Power Requirement Item Symbol Rating Unit
    Input voltage VIN +5DC +-5% 500mA(max.) V